Aeg-Electrolux L14950A Instrukcja Użytkownika Strona 1

Lavamat 14950 AUser manual Washer-dryer

DAILY USELoad the laundry1. Open the door by carefully pulling thedoor handle outwards. Place the laundryin the drum, one item at a time, shakingthem

Select the required programme by turning the programme selector dial (1)You can choose the right programme for any type of laundry following the descr

WARNING!Not all the options are compatible among themselves. The symbols of the incompatible op-tions disappear.Anyway, if an option, which is not com

SUPER QUICK optionBy selecting this option, it will be possible to reduce the washing duration to wash lightlysoiled laundry.The display will show the

Cancelling the delayed start• Set the washing machine to PAUSE by pressing the button 7;• Press button 8until the symbol ’ is displayed;• Press the b

• reduce the spin speed if needed, by pressing the relevant button• press the button 7• when the programme has finished the display shows a blinking

a few seconds on the display near the duration value. Press then button 7 to startthe programme. A black dash flashes under the DRYING symbol.Note!The

– 900 r.p.m. for cottons and synthetic with electronic drying;– 900 r.p.m. for cottons and 700 r.p.m. for fabrics with timed drying.5. Select a drying

Programme - Maximum and Minimum Tempera-ture - Cycle Description - Maximum Fabrics Load -Type of LaundryOptionsDetergent Com-partment40 - 60 MIX40°Mai

Programme - Maximum and Minimum Tempera-ture - Cycle Description - Maximum Fabrics Load -Type of LaundryOptionsDetergent Com-partmentDELICATES40° - 30

Thank you for choosing one of our high-quality products.To ensure optimal and regular performance of your appliance please read thisinstruction manual

Programme - Maximum and Minimum Tempera-ture - Cycle Description - Maximum Fabrics Load -Type of LaundryOptionsDetergent Com-partment20 MIN. - 3 KG30°

Degree of Drying Type of Fabric Max LoadCUPBOARD DRYSuitable for items to put away without iron-ingSynthetics and mixed fab-rics (jumpers, blouses, un

Removing stainsStubborn stains may not be removed by just water and detergent. It is therefore advisableto treat them prior to washing.Blood: treat fr

Quantity of detergent to be usedThe type and quantity of detergent will depend on the type of fabric, load size, degree ofsoiling and hardness of the

Garment labelsFor drying, follow the indications given on the manufacturer’s labels:• = May be tumble dried• = Drying at high temperature• = Drying at

• Select the hottest cotton wash programme.• Use a normal measure of detergent, must be a powder with biological properties.External cleaningClean the

Door sealCheck from time to time the door seal and objectsthat could be trapped in the fold.Drain pumpThe pump should be inspected regularly and parti

7. When no more water comes out, un-screw the pump cover by turning it an-ti-clockwise and remove the filter. Usepliers, if necessary. Always keep a r

Cleaning the water inlet filtersIf the appliance doesn't fill, it takes a long time to fill with water, the starting button blinksyellow or the d

Frost precautionsIf the machine is installed in a place where the temperature could drop below 0°C, proceedas follows:1. close the water tap and unscr

Frost precautions 29Emergency emptying out 29WHAT TO DO IF… 29TECHNICAL DATA 33CONSUMPTION VALUES 34INSTALLATION INSTRUCTIONS 34SPECIAL AC

Problem Possible cause/SolutionThe washing machine does not start:The door has not been closed. • Close the door firmly.The plug is not properly inser

Problem Possible cause/SolutionThere is water on the floor:Too much detergent or unsuitable detergent(creates too much foam) has been used.• Reduce th

Problem Possible cause/SolutionSpinning starts late or the machine does notspin:The electronic unbalance detection device hascut in because the laundr

If you are unable to identify or solve the problem,contact our service centre. Before telephoning,make a note of the model, serial number and pur-chas

CONSUMPTION VALUESProgramme Energy consumption(KWh)Water consumption(litres)Programme duration(Minutes)White Cottons 95° 2.5 62For the duration ofthe

1. After removing all the packaging, care-fully lay machine on it’s back to removethe polystyrene base from the bottom.2. Remove the power supply cabl

4. Slide out the relevant plastic spacers.5. Open the porthole, take out the inlethose from the drum and remove thepolystyrene block fitted on the doo

Positioning and levellingInstall the machine on a flat hard floor.Make sure that air circulation around the machineis not impeded by carpets, rugs etc

3. Set the hose correctly by loosening thering nut. After positioning the inlethose, be sure to tighten the ring nutagain to prevent leaks.4. Connect

This could be done by tying it to the tapwith a piece of string or attaching it tothe wall.2. In a sink drain pipe branch. Thisbranch must be above th

• Do not use your washing machine to wash articles with whalebones, material withouthems or torn material.• Always unplug the appliance and turn off t

WARNING!Should the appliance power supply cable need to be replaced, this must be carriedout by a Service Centre.ENVIRONMENT CONCERNSThe symbol on t

41

42

43

www.aeg.com/shop 132947643-A-032012

• Plastic detergent dispensers should not remain in the drum during the drying cycle, asthe plastic used is not designed to withstand the heat. If you

1654321Detergent dispenser drawer2Control panel3Door opening handle4Rating plate5Drain pump6Adjustable feetDetergent dispenser drawer Compartment for

1234567 891Programme selector dial2SPIN reduction button3AUTODRY button4DRYING TIME button5OPTION button6OK button7START/PAUSE button8DELAY START butt

DISPLAY9.1 9.2 9.3 9.49.99.89.79.69.59.1 - Spin Speed indicator, RINSE HOLD , NIGHT CYCLE - symbols9.2 - Drying degree indicator, allowed by the s

After selecting a drying programme, the drying time is displayed in minutes and/or hours(max 250 mins).After the programme has started , the time rema