Aeg-Electrolux HK654070IB Instrukcja Użytkownika Pobierz pdf (Strona 20)

• Use a strain relief clamp on cable.

• Use the correct mains cable of type H05BB-F Tmax 90°C (or higher) for a single phase or

two phase connection.

• Replace the damaged mains cable with a special cable (type H05BB-F Tmax 90°C; or

higher). Speak your local Service Centre.

The appliance must have the electrical installation which lets you disconnect the appliance

from the mains at all poles with a contact opening width of minimum 3 mm.

You must have correct devices to isolate: line protecting cut-outs, fuses (screw type fuses

removed from the holder), earth leakage trips and contactors.

To attach the seal to the rabbet

• Clean the rabbet in the work surface.

• Bond the seal stripe supplied on the upper surface of the rabbet along the edges of the

cut out section.

• Cut the seal stripe into four pieces in relation to the length of the edges of the rabbet.

• For the four corners of the rabbet the ends of the seal stripes must be cut into mitres. Do

not bond the ends over one another.

• Bond the seal stripe flush into the corner of the rabbet. Make sure that no silicon com-

pound can get below the glass ceramic when grouting.

• Do not extend the tapes.

Assembly

min. 500 mm

min.

50 mm

min.

50 mm

584

514

490

min. 600mm

560

R10mm

R5mm

12mm

7mm

min.

25 mm

min.

20 mm

min.

28 mm

20 Installation instructions

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 63 64

Brak uwag

Aeg-Electrolux HK654070IB Instrukcja Użytkownika Strona 20